DS-K1107AE

Manufacturer reference

Manufacturer details describe the cited version. Confirm the exact unit and intended system.

Reader and controller selection

Device class

Card Reader

Processor reference

32-bit processor. This is not a credential capacity, door count or benchmark guarantee.

Controller communication

The manual describes communication with an access controller using RS-485 or Wiegand. Confirm the actual controller and firmware; this is a reader, not a complete standalone door controller.

RS-485 encryption reference

AES encryption is described for the RS-485 link only. The manual does not establish key length, provisioning, OSDP Secure Channel or encryption of Wiegand.

Body material

PC+ABS is stated for the family. This does not establish a metal enclosure, numerical IP rating or corrosion category.

Power and protocol configuration

Power connection reference

The cable table identifies PWR as +12 V DC and a separate GND. Verify the complete supply circuit; no PoE or lock-power output is established.

Long-run power condition

When powered by the controller, the manual recommends a supply distance no longer than 100 m. Beyond 100 m it advises an external non-switched linear 12 V DC supply, +/-10%. This is not a guaranteed communication distance or a completed voltage-drop calculation.

DIP-bank and reader addressing

An eight-position DIP bank is shown; positions 1-4 set the RS-485 address. This does not establish the number of readers supported by a controller.

Protocol selection

DIP position 6 selects Wiegand or RS-485. Match the actual reader and controller before configuration; the modes are alternatives.

Wiegand format condition

DIP position 7 selects 26-bit or 34-bit Wiegand only when position 6 is in Wiegand mode. Do not apply this selector to RS-485.

RS-485 termination condition

DIP position 8 controls matched resistance for RS-485 only. Confirm the actual bus layout; no universal termination or cable-length approval is inferred.

Feedback and installation environment

Tamper reference

A built-in tamper-proof module is described. The cable table marks the TAMPER lead as available in Wiegand mode; do not infer identical signalling in every mode.

Buzzer and indicator references

The component drawing identifies a buzzer and indicator; the status chapter describes visual and audible feedback. Its generic authentication examples do not establish fingerprint or keypad hardware on this model.

Operating-temperature reference

The manual gives an appropriate temperature of -20 to 65 degrees C. Confirm the actual equipment specification and environment; the number is not an outdoor or condensation approval.

Reader-spacing and exposure cautions

The manual advises more than 30 cm between multiple readers and a waterproof shield in outdoor or permeable environments. Neither a shield nor an environmental installation approval is automatically included.

Selection notes

• Manufacturer reference applies only to the complete DS-K1107AE identity in the retained document. Confirm the actual reader generation, controller, credentials, power and installed firmware; this is not an installed-system or supply approval.
• A reader is not a complete access controller or powered lock. Confirm the full controller, card technology, firmware, quantity and power arrangement.
• Keep DS-K1107 and DS-K1107A generations, E/M card variants, keypad versions and regional ordering codes distinct; do not merge IDs or reuse firmware by similar name.
• ISD supplies products only. Stock, price, ETA, local warranty, included credentials/adapters/fixings and installation arrangements are confirmed separately.

Official documents

• Hikvision DS-K1107A series official user manual

Manufacturer source checked 2026-10-20. The supplied unit and local terms require confirmation.